 |
|
|
|
|
|
|
 |
 |
 |
|
|||
 |
|
|||||
2021 Arch St., Philadelphia, PA 19103
Phone: 856.491.5901 |
|
|||||
 |
|
|||||
 |
 |
 |
 |
|
||
 |
 |
|||||
Material Data Sheets - Chart 2
|
Property |
Units | Test Method ASTM |
Delrin 500CL |
TFE Fluoro- carbon |
Kynar® PVDF |
Cast Nylon |
Nylon MD |
| Coefficient
of Linear Thermal Expression |
in./in./°F | D-696 | 6.8
x 10(-5) (85-140°F) |
5.5-7.5 x 10(-5) | 4.4-7.9 x 10(-5) | 5.0 x 10(-5) | 3.5 x 10(-5) |
| Deformation
under Load (122°F, 2,000 psi) |
% | D-621 | 0.7 | 3-7 | -- | 0.5 - 1.0 | 0.5 - 2.5 |
| Deflection
Temperature, 264 psi |
°F | D-648 | 255 | 100-140 | 176-194 | 200-425 | 200-470 |
66 psi |
°F | D-648 | 338 | -- | 234-284 | 400-425 | 400-490 |
| Melting Point | °F | D-789 | 347 | 621 +/- 9 | 312-334 | 430 +/- 10 | 482-500 |
| Continuous Service Temperature in Air (max) | °F | -- | 180 | 500 | -- | 200-225 | 180-200 |
| Dielectric
Strength, Short Time |
volts/mil. | D-149 | 40 (125mils.) |
500-650 | -- | 500-600(2) | 300-400(2) |
| Volume Resistivity | ohm-cm. | D-257 | 5 x 10(14) | > 10(17) | 2 x 10(14) | -- | 25 x 10(13) |
| Dielectric Constant, 60 Hz | -- | D-150 | 3.5 | 2.0 - 2.1 | 8.40 | 3.7 | - |
10(3) Hz |
-- | D-150 | 3.5 | 2.0 - 2.1 | 7.46 | 3.7 | -- |
10(6) Hz |
-- | D-150 | 3.5 | 2.0 - 2.1 | 6.10 | 3.7 | -- |
| Property | Units | Test Method ASTM |
Delrin 500CL |
TFE Fluoro- carbon |
Kynar® PVDF |
Cast Nylon |
Nylon MD |
| Water
Absorption, Immersion (24 hours) |
% | D-570 | .27 | 0.00 - 0.05 | .04 - .06 | 0.6 - 1.2 | 0.5 - 1.4 |
| Water Absoption, Saturation | % | D-570 | 1.00 | -- | -- | 5.5 - 6.5 | 6 - 8 |
| Acids, Weak, 73°F | -- | -- | A | A | A | A | A |
| Acids, Strong, 73°F | -- | -- | U | A | A | U | U |
| Alkalies, Weak, 73°F | -- | -- | A | A | A | A | A |
| Strong, 73°F | -- | -- | U | A | A | A | A |
| Hydrocarbons, Aromatic, 73°F | -- | -- | A | A | A | A | A |
| Hydrocarbons, Aliphatic, 73°F | -- | -- | A | A | A | A | A |
| Ketones, 73°F | -- | -- | A | A | -- | A | A |
| Ethers, 73°F | -- | -- | A | A | -- | A | A |
| Esters, 73°F | -- | -- | A | A | -- | A | A |
| Alcohols, 73°F | -- | -- | A | A | A | A | A |
| Inorganic
Salt Solutions, 73°F |
-- | -- | -- | A | -- | A | A |
| Continuous Sunlight, 73°F | -- | -- | -- | A | -- | L | L |
Key
| A | = Acceptable Service | (1) | ASTM B-1457 used for thin specimens |
| L | = Limited Service | (2) | .080" thick |
| U | = Unacceptable | (3) | 122 F, 4,000 psi |
| NR | = Not Rated | (4) | ASTM
D-1708 (1/8" thick specimen @ .05"/min.) |
| -- | = Must Check Concentration | (5) | 150 F, 4,000 psi |
| (6) | .040" thick | ||
| (7) | Specimen 1/8"
thick, 2" diameter |
|
|
|
|
|
|
|
|
|
|
 |
 |
 |
 |
|
|||||
 |
 |
 |
|
|
|||||
 |
 |
|
|||||||